Method For Adjusting The Setting Value Of Vacuum Circuit Breaker

Dec 11, 2024 Leave a message

Adjust the breaking current
1. Open the vacuum circuit breaker and connect the ammeter to the output terminal.

2. Adjust the breaking current and increase the current value until the vacuum circuit breaker triggers a trip.

3. Rotate the adjustment knob (usually on the side of the vacuum circuit breaker) counterclockwise to decrease the current value until the circuit breaker no longer trips.

4. Rotate the adjustment knob clockwise as needed to slightly increase the current value for greater safety margin.

Attention: When adjusting the breaking current, ensure that the maximum range of the ammeter is greater than the rated current of the circuit breaker, and adjust it according to actual needs.

Adjust the closing current
1. Connect the ammeter to the incoming terminal.

2. Adjust the closing current and increase the current value until the vacuum circuit breaker closes.

3. Rotate the adjustment knob counterclockwise to decrease the current value until the circuit breaker no longer recognizes closure.

Attention: When adjusting the closing current, the load should be disconnected, otherwise misjudgment may occur.

Send Inquiry

Send Inquiry